ODroid-C1 Assembly

The assembly of the parts went very quickly. Maybe a few minutes at most, only taking longer because I was taking pictures the entire time.

Raw board
DSCF1012

Heatsink, make sure you remove the thin plastic tape covering the heat transfer medium. When you install it make sure it fully covers the CPU, the ram will not get hot like the CPU, and if you only partially cover the CPU then you will not get the full heat dissipation possible. The heatsink attaches by simply pushing the plastic clips through the holes in the board. Very clean and easy install.
DSCF1014

Heatsink attached, looks sweet!
DSCF1015

Attached eMMC mini board. Very tiny, you need to carefully align the board and then press it firmly to click into place.
DSCF1018

In the case. Much cleaner than my typical lego case that I use for the Raspberry-Pi!
DSCF1022

DSCF1024

DSCF1025

Previous Step: Unboxing
Next step: Configuration